Automatic spinning machine is a kind of machine commonly used in processing factories in modern society. Many people who are ready to work in this industry do not know what problems they should know when using automatic spinning machine in order to avoid wrong operation.

First of all, the fully automatic spinning machine should be very familiar with the position of the emergency stop button switch, so that when it is needed, it will be pressed without looking for, and the machine must be cut off before installing the fuse. Have enough work space to avoid danger. The ground should be clean and dry to prevent accidents. Before using the switch, be sure not to mess with the switch. If a task requires more than two people to complete, then, at each step of operation, we know that the automatic spinning machine is equipped with many safety devices to prevent the operator and equipment from being damaged or damaged.

Secondly, no matter which control method is adopted in the automatic spinning machine, to a large extent, the determination and output of the spinning lane depends on the operator's skilled skills. Therefore, the nc automatic programming technology will be an important research topic in the future. It should only input the profile of the workpiece, and the program should automatically input the shape, size and shape of the workpiece, so as to determine and input the cycle times and produce qualified products.

In the field of metal processing engineering, spinning is a new technology of non - chip forming of metal products. This molding technology has the advantages of good deformation condition, good product performance, small dimensional tolerance, high material utilization ratio and wide product range. However, during the processing of automatic spinning machine, mold deformation will occur. Many people do not know much about it. In fact, as long as they master the deformation law, such deformation can be prevented.

1. The mold structure design of automatic spinning machine should be reasonable, the thickness should not be too large, and the shape should be symmetrical. The mold of automatic spinning machine with large deformation should be mastered, and machining allowance should be reserved.

2. Reasonable selection of heating temperature and control of heating speed. For precision and complex moulds, slow heating, preheating and other equalizing heating methods can be adopted to reduce mould heat treatment deformation.

3. On the premise of ensuring the mold hardness of the automatic spinning machine, pre-cooling, fractional cooling quenching or temperature quenching process should be adopted as far as possible. For some precision and complicated molds, pre-heat treatment, aging heat treatment and tempering nitrification heat treatment can be adopted to control the precision of the mold.

4. When repairing the defects such as mould sand holes, pores and wear, choose the repair equipment with little thermal influence, such as cold welding machine, so as to avoid the deformation in the repair process.